Elestoria.
Hardware the data asked for.

Every Elestoria product moves through the same three states. It begins as parametric CAD, engineered against the specific shortcomings Skyros found in the incumbent products. The assembly is resolved down to every spring and fastener, prototyped and lived with on real desks, and only then released to production tooling. The renders below are from the dock’s original 2022 CAD files.

Phase 1 · CAD

Engineered to the data

Arm angle, grip travel, and the gravity-lock geometry are set by the device range the data shows people actually dock: up to 17.3″, 1.5″ thick.

Phase 2 · Exploded

Every part, accounted for

The assembly opened up: grip arms with rubber caps, the sliding rail carriage, springs, pins, and fasteners. The gravity lock is purely mechanical: nothing to power, nothing to pair.

Phase 3 · Production

The finished form

Anodized aluminum in production trim, holding a closed laptop on a footprint smaller than the device itself, QC-inspected at the factory and again at the freight forwarder.

fig. 07 one product, three states · from the original ELE-VD01 CAD files

fig. 08 studio views · three-quarter, grip open, and device docked